Moving A Part Of A Continuous Program In Parallel Partially - Brother BAS H Series Instruction Manual

Moving a part of a continuous program in parallel partially

Move a part of a continuous program in parallel to the position before the next feed is started. The following describes
how to move only pattern B in parallel.
2"
Feed
Start point
2
3"
1 3
Pattern A Pattern B
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch .
3. Touch .
4. Use to position the cursor
of pattern B.
5. When you press the
change to red lines and it will be selected.
6. Press .
4
Feed
5
Pattern C
at the outline
key once, the outline will
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
7. Use the jog key to move the cursor
8. Press .
Pattern B will move to 2''.
9. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20).
To set parallel movement in the middle of stitch data,
touch , and then touch
points to move in parallel, and then move the sewing
points.
The sewing points which are moved are connected by
feeding.
(In the example given below, 6-3 which are in
between 2 and 4 are moved to 6"-3".)
Start point
Feed
6
3
1
Pattern A Pattern B
to 2''.
, select the sewing
2
4
Feed
6"
3"
5
Pattern C
73