Basting - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Basting

The following describes how to program basting from point C to point F.
1. Carry out steps 1 to 3 in "Programming procedure"
(page 17).
2. Use the function for creating straight lines to create
an outline from A to C.
* Refer to "Pattern with lines" (page 52).
3. Touch .
4. Touch .
56
5. Use the jog key to move the cursor
6. Press
7. Repeat steps 5 and 6 to move the cursor
8. Press
9. Repeat step 2 to create the outline from F to H.
* Refer to "Pattern with lines" (page 52).
10. Carry out steps 5 and after in "Programming
procedure" (page 18).
BAS H series, Programmer
.
twice.
to D.
to F.