Creating Needle Drop Data; Creating Feed Data; Creating Basting Data - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Creating needle drop data

Create needle drop data for the current needle position.
1. Touch .
2. Touch .

Creating feed data

Create (feed) data to move the needle to the next position without needle drop at the current position.
1. Touch .
2. Touch .

Creating basting data

Create basting data.
1. Touch .
2. Touch .
26
3. Make the settings for each item.
* Refer to "Setting parameters" (page 27) for details
on the setting method.
4. Use the jog key to move the cursor
where you would like to set the needle down position,
and then press
To change the maximum pitch, carry out the same
procedure as in step 3 to change the setting.
5. Repeat step 4 until the needle drop position can be set.
Move the cursor
3. Make the settings for each item.
* Refer to "Setting parameters" (page 27) for details
on the setting method.
4. Use the jog key to move the cursor
where you would like to set the feed, and then press
3. Make the settings for each item.
* Refer to "Setting parameters" (page 27) for details
on the setting method.
4. Use the jog key to move the cursor
where you would like to set basting, and then press
.
5. Repeat step 4 until the basting position can be set.
Move the cursor
twice.
BAS H series, Programmer
.
to the end point, and then press
twice.
twice.
to the end point, and then press
to the point
to the point
to the point