Moving An Outline Component Point - Brother BAS H Series Instruction Manual

Moving an outline component point

1. .
Touch
2. .
Touch
3. Touch to set the selection method (Manual
select, Range select) and method for moving the
cursor (Move freely, Snap to needle point).
* If the method for moving the cursor is set to "Move
freely", the cursor can be moved to any desired position.
* If the method for moving the cursor is set to "Snap to
needle point", the cursor will move to the sewing point.
■ Selecting continuous component points for
editing
4. Touch to set the selection method to "Range
select".
5. Use to move the cursor
for the range that you would like to select.
* You can move the cursor continuously by holding down
the key.
6. Press .
7. Use to move the cursor
of the range that you would like to select. The
component points will change to red, and the points
from the start point to the end point will be selected.
* You can move the cursor continuously by holding down
the key.
8. Press
the cursor
move the component point.
9. Press
■ Manually selecting component points for
4. Touch
"Manual select".
Selection method
5. Use
point that you would like to move.
Method for
moving the cursor
* You can move the cursor continuously by holding down
6 When you press the
point will change to red and it will be selected.
7. If there is more than one component point that you
would like to move, repeat steps 5 and 6.
* To select all outlines
Selection method
* To unselect all outlines
Method for
moving the cursor
to the start point
8. Press
the cursor
move the component point.
9. Press
to the end point
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
once, and then use the jog key to move
to the place where you would like to
.
editing
to set the selection method to
to move the cursor
the key.
key once, the component
When you press the
component point will be unselected.
Hold down to select all component points in
an outline.
Hold down to unselect all selected component
points.
once, and then use the jog key to move
to the place where you would like to
.
Selection method
Method for
moving the cursor
to the component
key once, the selected
39