Changing The Line Type Of An Outline; Adding And Deleting Backtack Stitches For An Outline - Brother BAS H Series Instruction Manual

Changing the line type of an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to change the line type for.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
5. If there is more than one outline that you would like to
change the line type for, repeat steps 3 and 4.

Adding and deleting backtack stitches for an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to add or delete backtacking
for.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
5. If there is more than one outline that you would like to
add or delete backtacking for, repeat steps 3 and 4.
*To select all outlines
Hold down to select all outlines.
at the outline
key once, the outline will
key once, the selected
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Touch to set the line type (Running, V
Zigzag, N Zigzag, Keep Current Shape), pitch and
running generation mode (Equal Pitch, Prioritize
Pitch).
* For details on the setting method for zigzag stitches,
refer to "Zigzag stitch" (page 59).
* Outlines which consist of stitches/feeding/basting and
outlines which have been loaded from *.SEW files
cannot have their line types changed.
7. Press .
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Touch to set the backtack type (start
position), number of backtack stitches (0 to 9),
backtack type (end position) and number of backtack
stitches (0 to 9).
*
Backtack stitch type ...
No Back Tack, V Back, N Back, Overlap
* The "Overlap" setting can only be set for closed
outlines (circles specified by radius, circles specified
by diameter, circles specified by three points, ellipses,
rectangles, etc.).
7. Press .
Line type
Sewing pitch
Running generation
mode
Backtack type (start
position)
Number of backtack
stitches (start position)
Backtack type (end
position)
Number of backtack
stitches (end position)
35