Welding Process Selection Menu (Process) - CEA DIGITECH vision PULSE 3200 Operator's Manual

WELDING PROCESS SELECTION Menu (PROCESS)

To access the PROCESS SELECTION Menu (PROCESS) push the MENU K
ENCODER K
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
The following processes are available:
• MIG PULSE (only DH)
• MIG DUAL PULSE (only DH)
• MIG-MAG SYNERGIC
• MIG-MAG MANUAL
• VISION.COLD (if activated)
• VISION.PIPE (if activated)
• VISION.POWER (if activated)
• VISION.ULTRASPEED (if activated)
• MMA
• TIG LIFT
• TIG LIFT PULSE
• JOB (if JOBS have been created)
• SEQUENCES (if SEQUENCES have been created)
It is not possible to access the PROCESS SELECTION Menu (PROCESS) via the HT5 control panel.
"DH" / "VS" CONTROL PANEL
MENU K
EY
- SX
NOB
MENU K
EY
- SX
NOB
Provides access to the next menus.
Select the welding process.
This key is used to access PRE-SETTING for the process selected.
"HT5" CONTROL PANEL (not used with DH 32 and VS 32)
.
EY
MIG PULSE
MIG DUAL PULSE
MIG/MAG SYNERGIC
MIG/MAG MANUAL
VISION.COLD
VISION.PIPE
VISION.POWER
1011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
VISION.POWER
VISION.ULTRASPEED
MMA
TIG LIFT
TIG LIFT PULSE
JOB
SEQUENCES
1011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
7
ENTER/MEM K
EY
ENTER/MEM K
EY