About This Manual - National Instruments PCI E Series Programmer's Manual

About This Manual

© National Instruments Corporation
This manual describes the registers and register map of the PCI E Series
boards and contains information concerning their register-level
programming.
The DAQ-STC, a National Instruments system timing controller ASIC, is
the timing engine that drives the PCI E Series boards. Consequently, the
timing and programming sections in this manual repeat certain information
from, or draw your attention to, sections in the DAQ-STC Technical
Reference Manual. You must use your register-level programmer manual
along with the DAQ-STC Technical Reference Manual for a complete
understanding of PCI E Series board programming.
Unless otherwise noted, text applies to all boards in the PCI E Series. The
PCI E Series boards are:
• PCI-MIO-16E-1
• PCI-MIO-16E-4
• PCI-MIO-16XE-10
• PCI-MIO-16XE-50
• PCI-6023E
• PCI-6024E
• PCI-6025E
• PCI-6031E (MIO-64XE-10)
• PCI-6032E (AI-16XE-10)
• PCI-6033E (AI-64XE-10)
• PCI-6052E
• PCI-6071E (MIO-64E-1)
The PCI E Series boards are high-performance multifunction analog,
digital, and timing I/O boards for the PCI bus computers. Supported
functions include analog input, analog output, digital I/O, and timing I/O.
xiii PCI E Series RLPM