Misc Command Register - National Instruments PCI E Series Programmer's Manual

Misc Command Register

The Misc Command Register contains one bit that controls the PCI E Series analog trigger
source. The contents of this register are cleared upon power up and after a reset condition.
Address:
Type:
Word Size:
Bit Map:
7 6
Int/Ext Trig Reserved
Bit
7
6–0
© National Instruments Corporation
Base address + 0F (hex)
Write-only
8-bit
5 4
Reserved Reserved
Name Description
Int/Ext Trig Internal/External Analog Trigger—This bit controls the
analog trigger source. If this bit is set, the output of the
PGIA2 is selected as the trigger source. If this bit is
cleared, the TRIG1 signal from the I/O connector is
selected as the trigger source.
Reserved Reserved—Always write 0 to these bits.
Chapter 3
3 2
Reserved Reserved
3-5
Register Map and Descriptions
1 0
Reserved Reserved
PCI E Series RLPM