Christie M Series Service Manual page 34

Error message
TI Red Sys
Thermal Def
Thermal Det: <number>
Thermal Dev
Thermal: <number
Ver Data N/A
YNF
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Conditions
Red channel TI system failure
Configuration file error
Thermal sensor detection failure
Fan failed to initialize
Configuration file error
Configuration file error
Yellow notch filter is not detected
Troubleshooting
• Check the red satellite
communication cables for loose
connection.
• Replace the red satellite
communication cable.
• Replace the light engine.
• Check cables for loose
connections.
• Re-install the projector
software.
• If sensor is attached to a
harness, check for loose
connection.
• If sensor is attached to a board,
replace the board.
• Re-install the projector
software.
• Replace the panel driver.
• Re-install the projector
software.
• Replace the panel driver.
• Re-install the projector
software.
• Replace the panel driver.
Check cables for loose connections.
34