Replacement procedures
Before servicing the projector, perform the following tasks.
•
Always power down and disconnect power sources prior to servicing.
•
Allow the unit to cool for a minimum of 10 minutes.
•
Follow all service safety warnings and guidelines (on page 12).
•
Always read and understand all instructions before starting the procedure.
•
When re-installing a module, follow removal instructions in reverse unless otherwise indicated.
•
When re-connecting harnesses, see Interconnections (on page 92).
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Parts and module replacement
44