Christie M Series Service Manual page 32

Error message
Engine Mode
Fan Install
Fan Param: <number>
Fan Seq: <number>
Fan therm: <number>
Green Bias
Green Comm
Green Offset
Green Reset
Green Therm
HW Install
LCDVErr File: <number>
LED Status
LampVErr File: <number>
LiteLoc Cal Failure
Red Bias
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Conditions
Engine failed to enter normal
operation
Failed to initialize the projector fans
Failed to read the fan configuration
parameter
Thermal device is not recognized
Thermal operations failed on a fan
Green bias under voltage
Green satellite communication error
Green offset under voltage
Green reset under voltage
Green DAD thermal shutdown
Critical hardware installation failure
LCD firmware file version conflict
LED status display is not detected
Lamp software file version conflict
LiteLoc calibration failure
Red bias under voltage
Troubleshooting
Replace the panel driver.
• Check cables for loose
connections.
• Re-install the projector
software.
Re-install the projector software.
Re-install the projector software.
• Check cables for loose
connections.
• Replace the fan.
Replace the light engine.
• Check the green satellite
communication cables for loose
connection.
• Cycle AC power.
Replace the light engine.
Replace the light engine.
Allow the projector to cool down.
• Check engine communication
cables for loose connections.
• Check thermal sensor cables for
loose connections.
• Check fan cables for loose
connections.
• Cycle AC power.
• Replace the keypad.
Check rear status panel harness for
loose connection.
• Cycle AC power.
• Replace the panel driver.
• Re-calibrate LiteLoc.
• Replace lamps.
Replace the light engine.
32