Adjusting The Integrator Tilt; Adjusting The Integrator Focus Lens - Christie M Series Service Manual

A Capscrew (1 of 2)
B Setscrew (1 of 2)
C Pivot screw
1. Remove the top cover (on page 45).
2. Unlock the two setscrews (B).
3. To make adjustments turn the pivot screw (C) 90-180 degrees.
4. Adjust both capscrews to pivot the fold mirror back and forth.

Adjusting the integrator tilt

Complete the following procedure to adjust integrator tilt.
1. Remove the top cover (on page 45).
2. Loosen the screw.
3. Adjust the integrator tilt by moving the hex driver up, down, left, or right.
4. Tighten the screw once you achieved adjustment.

Adjusting the integrator focus lens

Complete the following procedure to adjust the integrator focus lens.
1. Remove the top cover (on page 45).
2. Loosen the two setscrews.
Do not loosen the focus lens handle.
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Service setups
24