Christie M Series Service Manual page 80

25. Set the lens mount beside the projector, all harness and wires are still attached.
When replacing, the lens mount sits on dowel pins.
26. Remove both side vents and any filters, if fitted.
a) Through the rear vent opening, remove one screw from the ground strap attached to the
light engine box.
b) Through the front vent opening, remove one screw from the harness clip attached to the
light engine box.
27. Disconnect fan #4 at the quick disconnect coupling.
When reassembling, connect fan #4 before fastening screws in steps 27 and 28.
28. Remove the three screws and lock washers from inside the light engine compartment.
29. Remove the one screw and lock washer outside the light engine compartment.
30. Remove the optical assembly by lifting it up and out of the projector.
31. To re-install, follow these steps in reverse order.
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
80