Christie M Series Service Manual page 31

Error message
Driver Over-Temp
Driver Voltage Low
Driver Voltage High
Driver DC Drive Err
Driver Low Input Voltage
Driver Voltage Surge
Driver Thermal Sensor Err
Driver Mismatch
E-Shutdown
Eng Config
Eng Init
Eng Install
Eng OpStatu
Eng Status
EngVErr File: <number>
Engine Comm
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Conditions
Electronics card cage is running
hotter than expected
Unexpected error from the lamp
driver
Voltage going to the lamp is higher
than expected, usually due to a
missing or broken lamp
Unexpected error from the lamp
driver
Unexpected error from the lamp
driver
Unexpected error from the lamp
driver
Unexpected error from the lamp
driver
Two different lamp drivers are in the
projector
Emergency shutdown has occurred
to protect the projector from
damage
Engine configuration failed
Critical engine initialization failure
Critical engine installation failure
Engine failed operational status
check
Engine failed full status check
Engine firmware or software version
file conflict
Engine communication failure
Troubleshooting
• Verify that the intake fan #7
and projector exhaust are
unobstructed.
• If the issue is not resolved,
replace the lamp driver.
Replace the lamp driver.
• Replace the lamp.
• If the issue is not resolved,
replace the lamp driver.
Replace the lamp driver.
Replace the lamp driver.
Replace the lamp driver.
Replace the lamp driver.
Ensure both lamp drivers are of the
same type and revision
Check and resolve the most recent
critical status message shown when
the projector reaches standby.
Re-install the projector software.
• Re-install the projector
software.
• Cycle AC power.
• Replace the panel driver.
• Re-install the projector
software.
• Cycle AC power.
• Replace the panel driver.
Replace the panel driver.
Replace the panel driver.
Re-install the projector software.
Replace the panel driver.
31