Reading Out Error Messages Using The Wbm; Firmware Update - Siemens SIMATIC RF185C Operating Instructions Manual

Service and maintenance

10.3 Firmware update

10.2.3

Reading out error messages using the WBM

Reading out error messages using the WBM
All the diagnostics messages of the reader are entered in the "Log" if a check mark was set
for "ERRORS" in the WBM configuration in "Settings - General". You will find further
information on the "Log" in the section "The "Diagnostics - Log" menu item (Page 74)".
10.3 Firmware update
The following options are available for updating the firmware of the communications
modules:
● Using WBM
● Using the TIA Portal (STEP 7 Basic / Professional V15.1 or higher)
In addition, the firmware of the readers connected to the communications module can be
updated. The firmware of the readers is updated using the TIA Portal (STEP 7 Basic /
Professional V15.1 or higher).
These alternative methods are described below.
134
SIMATIC RF185C, RF186C, RF188C
Operating Instructions, 10/2018, C79000-G8976-C512-01