Siemens SIMATIC RF185C Operating Instructions Manual page 57

Toolbar and status bar
On the left above the main window, there are four buttons for transferring/loading/storing the
displayed configuration. You can also operate these buttons directly with key combinations.
Table 7- 1
Icon
Note
Transferring a configuration
Please note that transferring a configuration can disrupt running user applications. In WBM,
an orange bar in the information area warns you when this is the case.
Note
Loading a configuration
Note that you cannot use the configuration file to transfer user profiles and passwords to
other communications modules. After loading the configuration file into a new
communications module, you may need to enable user management and create new user
profiles and passwords.
On the right above the main window there is the status bar with the following information:
● Date/time display of the communications module
● Display of the device status
● Drop-down list for selecting the user interface language
● Log-on/log-off area
SIMATIC RF185C, RF186C, RF188C
Operating Instructions, 10/2018, C79000-G8976-C512-01
The toolbar of the WBM
Description
Transfer configuration to communications module
With this button, you can transfer the configuration data set in the WBM to the com-
munications module.
Key combination: Ctrl + L
Load configuration from communications module
With this button, you can load the configuration data currently set on the communica-
tions module into the WBM.
Key combination: Ctrl + G
Save configuration as
With this button, you can save the configuration data set in the WBM on the PC.
Key combination: Ctrl + S
Load configuration from PC
With this button, you can load the configuration data stored on the PC in the WBM.
Remember that this data is only loaded in the WBM. To transfer the data to the com-
munications module, you also need to click the "Transfer configuration to communica-
tions module" button.
Key combination: Ctrl + O
Configuring with the WBM
7.2 The WBM
57