Siemens SIMATIC RF185C Operating Instructions Manual page 50

Configuring
6.2 Configuration via PROFINET IO
Parameter group "Module parameters" of the connected readers
In this parameter group, you can configure all module-specific parameters of the connected
readers.
Table 6- 4 Parameters of the parameter group "Module parameters" of the connected readers
Parameter
User mode
MOBY mode
Transmission
speed
Diagnostics
messages
50
Parameter value
RFID standard profile
FB 45
RF200/RF300/RF600;
MV400/MV500; MOBY
U/D normal addr.
19.2 kBd
57.6 kBd
115.2 kBd
None
Hard errors
Hard/soft errors
Default value Description
RFID standard pro- With this parameter, you select the block:
file
•
•
RF200/RF300/RF60 With this parameter, you set the mode of the
0; MV400/MV500; communications module.
MOBY U/D normal
•
addr.
Normal addressing: The transponder is ad-
dressed with physical addresses.
115.2 kBd With this parameter, you set the data transmis-
sion speed between the communications mod-
ule and reader.
When an optical reader is connected: The
transmission speed selected here must match
the transmission speed selected for the reader.
None With this parameter, you determine the extent
to which the reader-related diagnostic interrupt
messages are to be reported.
•
•
•
Operating Instructions, 10/2018, C79000-G8976-C512-01
RFID standard profile:
The program block for the Ident profile is
used in the controller.
FB 45:
Single tag mode. FB 45 is used in the con-
troller
RF200/RF300/RF600; MOBY U/D normal
addr.
None:
No alarms are generated.
Hard errors:
Critical hardware errors/faults are reported
by the S7 diagnostics.
Hard/soft errors:
Critical hardware faults and errors occurring
when processing commands are reported
by the S7 diagnostics.
SIMATIC RF185C, RF186C, RF188C