Siemens SIMATIC RF185C Operating Instructions Manual page 91

This case is intended purely for diagnostics purposes, so write access is no longer
possible here for OPC UA clients.
The assignment of the read points to the connected devices is derived from the read point
names. You can find these in the read point attributes.
Table 9- 1
Reader interface
1
2
3
4
The DisplayName can be adapted.
1)
Each OPC UA server publishes to the OPC UA clients its OPC UA functionalities via nodes
in its address area. You will find the read points or "RfidReaderDevices" under the node
"Objects > DeviceSet" in the address area of the OPC UA server of the RF18xC
communications modules.
Figure 9-2
You will find the methods/functions listed below under the following path in the address area
of a read point "Objects > DeviceSet > Readpoint_x1".
SIMATIC RF185C, RF186C, RF188C
Operating Instructions, 10/2018, C79000-G8976-C512-01
Assignment of read points; example based on an RF188C
BrowseName
Read_point_1
Read_point_2
Read_point_3
Read_point_4
Node "Objects > DeviceSet"
Programming via the OPC UA interface
9.1 Supported methods/functions
DisplayName
1)
Readpoint_11
Readpoint_21
Readpoint_31
Readpoint_41
91