Burst Mode Operations - Baker Hughes Masoneilan SVI II ESD Quick Start Manual

D. Burst Mode Operations
The Burst mode is when the HART
of being polled by a Master. Use this mode only for devices that are passive (i.e. not a HART
master), such as a HART
mount). Turning on Burst mode in cases where it is not required affects the communication
bandwidth.
To see how the Burst mode is configured see the SVI II ESD online help.
The Burst mode can send the following commands:
© 2018 Baker Hughes, a GE company, LLC. All rights reserved.
®
device continuously sends out data for a device not capable
®
to Analog converter (SPA from Moore Industries, Tri-Loop by Rose-
Cmd1: PV
Cmd2: %range/current
Cmd3: Dyn vars/current
Cmd9: Device vars w/status
Cmd33: Device variables
Figure 28 Burst Mode Configuration
Masoneilan SVI II ESD Quick Start Guide =| 99
®