7. Turn on the voltage source. On initial power up of a newly installed SVI II ESD, the
positioner runs in SETUP mode using the default factory-installed instrument
parameters. Once calibrated and configured and set to NORMAL, the positioner
cycles through the NORMAL cycle menu and the following values appear:
8. Proceed to"Configuration" on page 62 and "Calibration" on page 66.
NOTE
© 2018 Baker Hughes, a GE company, LLC. All rights reserved.
PRES: Pressure - unit of measurement and value
SIGNAL
POS (Position)
An exclamation point (!) appears in the display's top left corner to indicate
that further instrument status is available.
The safety function of the SIF (shutdown of the valve on demand)
must be tested after installation.
Masoneilan SVI II ESD Quick Start Guide =| 47