Recirculation Pump; Replacement Of The Recirculation Pump - Kodak M35 Service Manual

Recirculation Pump

Replacement of the Recirculation Pump

Dangerous voltage.
[1] Disconnect the main power.
[2] Disconnect the water supply.
[3] Remove the TOP COVER and the 2 SIDE
PANELS.
[4] Drain the 3 TANKS.
[5] Use PINCH CLAMPS on the tubing to prevent
leakage.
[6] Disconnect the tubing to the

RECIRCULATION PUMP.

[7] Remove the MOUNTING SCREWS.
[8] Remove the RECIRCULATION PUMP.
[9] Reverse the above procedure to install a new
RECIRCULATION PUMP.
2-34

Replacement of the Recirculation Pump

[10] Connect the water supply.
[11] Remove the PINCH CLAMPS.
[12] Fill the 3 TANKS with water.
[13] Connect the main power.
Never operate the RECIRCULATION
PUMPS if the TANKS are empty.
[14] Actuate the RECIRCULATION PUMPS.
[15] Check for agitation on the surface of the
solutions.
[16] Check for leakage.
[17] Drain the water thoroughly from the developer
and fixer TANKS and fill the TANKS with
developer and fixer.
MOUNTING
SCREW
RECIRCULATION PUMP
H112_0071BCE
H112_0071BA
981777