Replacement Of The Resilient Rollers In The Wash Rack - Kodak M35 Service Manual

Replacement of the Resilient Rollers in the Wash Rack

[1] Remove the:
• 2 SCREWS and the ID WASHER from the
TIE ROD
• SCREWS, WASHERS, DRIVE GEAR,
SPACERS, and BEARINGS from the DRIVE
and DRIVEN ROLLERS on the outside of
both SIDE PLATES
[2] Rotate the flat part of the SHAFT of the
DRIVE ROLLER to the up position.
[3] Move the DRIVE ROLLER to the non-drive
side and remove the KEY from the
SPROCKET.
H112_0105DCA
H112_0105DA
2-14
DRIVE
ROLLER
SHAFT
SPRING
(2)
DRIVEN
ROLLER
SIDE PLATE
Replacement of the Resilient Rollers of the Wash Rack
[4] Remove the 2 SPRINGS.
[5] Pull the 2 SHAFTS of the DRIVE ROLLER
and the DRIVEN ROLLER to the drive side to
remove them from the non-drive SIDE PLATE.
[6] Bend the SIDE PLATE slightly to allow
removal of the DRIVE ROLLER.
[7] Remove the THRUST WASHER, SPROCKET,
and SPACERS.
[8] Reverse the procedure to install new resilient
ROLLERS.
TIE
ROD
PIN
SPACER
KEY
PIN
SPROCKET
SHAFT
SPACER
BEARING
WASHER
ID WASHER
THRUST
WASHER
SCREW (2)
SPACER
SCREW
SCREW
DRIVE
GEAR
KEY
981777