Periodic Maintenance; General Information; Lubrication Table - Kodak M35 Service Manual

General Information

• This section includes additional
procedures that are not in the
Operator Manual, Publication
No. 981158.
• To provide for optimum operation of the
processor, it is important to use the
following procedures.
[1] Process 5 sheets of unprocessed film before
you begin the periodic maintenance. Check
for artifacts.
[2] Check for:
• cleanliness
• broken parts
• wear of parts
• leakage
• site specifications
[3] Install new parts for the broken parts and
parts that have wear.
Part
Main Drive Chain
Recirculation Pumps
Main Drive Motor
Gear Housing of the
Main Drive Motor
Dryer Blower Motor
Bearings
981777

Periodic Maintenance

NOTE

Lubrication Table

Lubricant
NLGI - No. 2 Lithium Ball
and Roller Bearing
Grease, TL-2324
Light oil, such as SAE
No. 20 Motor Oil,
TL-2244
No lubrication necessary
No lubrication necessary
Light oil, such as SAE
No. 20 Motor Oil,
TL-2244
Dangerous Voltage
• Disconnect the main power before
lubricating the parts.
• Do not allow any oil or grease to touch the
CROSSOVERS and RACK ASSEMBLIES or
to drip into the TANKS.
[4] Provide lubrication if necessary.
[5] Use the correct procedure to clean parts.
[6] Make the necessary adjustments.
[7] Process 5 sheets of unprocessed film in the
processor after you have performed any
service. Check for artifacts.
Frequency
As necessary.
Check each month.
Every 6 months.
--
--
Every 6 months.
Procedure
Apply to surface of
Chain.
Several drops in the oil
holes.
--
--
Several drops in the oil
holes.
3-1