Kodak M35 Service Manual page 41

[8] Remove the 2 GLAND NUTS, the
2 O-RINGS, the 2 WASHERS, and the HEAT
EXCHANGER from the TANK.
[9] Install the:
• new HEAT EXCHANGER
• 2 O-RINGS
• 2 WASHERS
• 2 GLAND NUTS
• TANK in the processor
• 2 FITTINGS, with new GASKETS if in the
fixer TANK
• WATER INLET TUBE, if the wash TANK
• TANK SEALS
• TANK CLIPS
• tubing
• RACK SUPPORT
[10] Pull the RACK SUPPORT toward the
non-drive side of the processor and install the
2 SCREWS.
[11] Connect the water and fill the 3 TANKS with
water.
[12] Check for leakage.
[13] Drain the water from the developer and fixer
TANKS. Fill the 2 TANKS with developer and
fixer.
[14] Connect the main power.
981777
GASKET (2)
FITTING (2)
WATER INLET
TUBE
Replacement of the Heat Exchangers
TANK
HEATER
EXCHANGER
O-RING (2)
WASHER (2)
GLAND NUT (2)
H112_0098CCA
H112_0098CA
2-33