Replacement Of The Dryer Heater Or The Heater Core - Kodak M35 Service Manual

Replacement of the Dryer Heater or the Heater Core

[1] Disconnect the main power.
[2] Remove the:
• TOP COVER
• DRYER RACK
• RECEIVING END COVER
• SIDE PANELS
Possible damage from electrostatic discharge.
[3] Disconnect CONNECTORS 801 and 802, not
shown, from the 800 CIRCUIT BOARD. See
the illustration on the next page for the
position of the 800 CIRCUIT BOARD.
[4] Disconnect TB2-1, TB2-3, TB2-5, and the
ground wire from the ELECTRICAL BOX.
[5] See the illustration on page 2-27. Remove
the:
• EXHAUST HOSE
• 4 SCREWS under the foam strips
• 6 MOUNTING SCREWS
• DRYER HEATER
[6] Do steps 7 - 10 to install only a new HEATER
CORE inside the DRYER HEATER. To install
an entire new DRYER HEATER, reverse the
above procedure.
2-24
[7] Loosen the 2 SCREWS.
[8] Remove the HEATER TOP COVER.
[9] Inside the DRYER HEATER:
(a) Remove the 4 HEX NUTS, not shown.
(b) Loosen the 4 MOUNTING SCREWS,
not shown.
(c) Remove the HEATER CORE.
[10] Reverse the procedure to install the new
HEATER CORE in the DRYER HEATER.
[11] Reverse steps 1 - 5 to install the DRYER
HEATER in the processor.
TOP COVER
H112_0028ACB
H112_0028AC
981777