Adjustment Of The Replenishment Pumps - Kodak M35 Service Manual

Adjustment of the Replenishment Pumps

[1] Remove the TOP COVER and the
RECEIVING BIN.
[2] Loosen the 2 SCREWS and remove the
PUMP COVER.
[3] Actuate the DETECTOR SWITCH, by lifting
the top DETECTOR ROLLER of the
DETECTOR CROSSOVER ASSEMBLY, until
the ADJUSTMENT SCREW is visible through
the hole in the BRACKET.
[4] Loosen the SETSCREW.
Do not adjust the LOCKNUT on the
other end of the ADJUSTMENT
SCREW.
[5] Rotate the ADJUSTMENT SCREW:
clockwise
counterclockwise
[6] Tighten the SETSCREW.
SETSCREW
Do not
adjust!
LOCKNUT
H112_0030BCB
H112_0030BC
981777
to increase the flow
rate
to decrease the flow
rate
REPLENISHMENT PUMP
ADJUSTMENT
SCREW

Adjustment of the Replenishment Pumps

BRACKET
PUMP COVER
SCREW (2)
[7] Check the flow rates and do steps 2 - 6 again
if necessary. See the table on page 2-41 for
various replenishment rates.
[8] Install the TOP COVER, the PUMP COVER,
and the RECEIVING BIN.
[9] Check that the REPLENISHMENT PUMPS
operate correctly by feeding a sheet of film
into the processor. See page 2-4.
DECREASE
BRACKET
HOLE
TOP COVER
H112_0115ACC
H112_0115AC
ADJUSTMENT SCREW
INCREASE
OUTPUT
2-37