Detector Switches; Adjustment Of The Detector Switches - Kodak M35 Service Manual

Adjustment of the Detector Switches

Moving parts.
[1] Remove the TOP COVER.
[2] Check the DEVELOPER RACK and the
DETECTOR CROSSOVER ASSEMBLY for
squareness. See pages 2-6 and 2-7.
[3] Install the DEVELOPER RACK and the
DETECTOR CROSSOVER ASSEMBLY.
[4] Set the clearance between the MAGNET and
the DETECTOR SWITCH on the drive side to
1.6 mm (0.06 or 1/16 in.).
[5] Check the clearance between the MAGNET
and the DETECTOR SWITCH:
(a) Energize the processor.
(b) Lift the top DETECTOR ROLLER.
2-4

Detector Switches

[6]
[7]
[8]
[9]
DETECTOR
ROLLER
DETECTOR
SWITCH (2)
SCREW
ROCKER ARM
Adjusting the Detector Switches
(c) Insert a 5 x 7 inch sheet of film.
(d) Move the drive side DETECTOR
SWITCH until the REPLENISHMENT
PUMP activates.
(e) Check that the REPLENISHMENT
PUMP stops in 3 seconds after you
remove the sheet of film.
Adjust the clearance between the MAGNET
and the DETECTOR SWITCH if necessary.
(a) Loosen the SCREW.
(b) Move the ROCKER ARM.
(c) Tighten the SCREW.
Do steps 4 - 6 to adjust the DETECTOR
SWITCH on the non-drive side.
Install the TOP COVER.
Check that the REPLENISHMENT PUMP
does not operate unless you feed film.
ROCKER
ARM
MAGNET (2)
1.6 mm
(0.06 in.)
DETECTOR
SWITCH (2)
H112_0112BCA
H112_0112BA
981777