Switch On/Off The Messages; Panic Function And Parameter Re-Load - Hammond XK-5 Owner's Manual

To locate this mode:
MENU/EXIT
See "Function mode" (P. 68) for operation details.
⓯ NOTE - VOLUME
Sets the volume (Control Change #7) of this zone. How-
ever, if CC# (20) is at "VOL", this setting value is null.
⓰ NOTE - PAN
Sets the Pan of this zone (Control Change #10).
⓱ NOTE - VELOCITY
Sets the character of the velocity to send to this zone.
Th e setting range is OF and 1 to 4. At OF, the velocity is
fi xed at 100. Th e "touch" (velocity response) of the key-
board progresses from 1 (heavier) through 4 (lighter).
⓲ EXPRESSION - MINIMUM
⓳ EXPRESSION - MAXIMUM
Sets the range to "compress" the expression information to
send to this zone.
In the XK-5 default, if the expression pedal is pulled fully
back, the output does not perfectly silent. If a GM sound
generator is used, the volume would go to zero. Th is is a
parameter to balance the two.
Th e setting range is MIN at 0 to 63, MAX at 64 to 127.
⓴ EXPRESSION - CONTROL NUMBER
Volume control diff ers by type by type of MIDI equipment
connected. Th is parameter sets the proper CC# to control
the volume / expression of connected MIDI equipment.
You can select 7: VOL, 11: EXP.
MESSAGE - DAMPER
Sets which controller to send the damper information to
this zone.
OFF:
Does not send.
CTRL1: A foot controller which connected CTRL1 jack.
CTRL2: A foot controller which connected CTRL2 jack.
ON EXP: The foot switch which placed on the Expression pedal.
ENTER
NOTE: The parameters in these modes are Patch parameters, and
are recorded to the Patch.

SWITCH ON/OFF THE MESSAGES

Th e MIDI messages which this keyboard may makes undesired
operation. It will prevent with switching off the each MIDI
message.
MIDI message which can switched Patch by Patch
Note, Expression, Damper(in this page)
MIDI message which switched by totally
Bank select, Program change, Volume, Pan (P. 126)

PANIC FUNCTION AND PARAMETER RE-LOAD

If a problem occurs to the MIDI system, it may be caused by a
cypher. When this keyboard and an external MIDI equipment
is connected, such a problem could happen due to the diff er-
ence between the setting contents of both equipment.
In such a case, touch both [ ], [ ] buttons. Both the "All
Note Off " and "Reset All Controllers" are sent to the MIDI
channels of all external zones (Panic Function), then the set-
tings of all external zones are reloaded (sent again).
127