Display - Hammond XK-5 Owner's Manual

footage of the Drawbar group [B]
ASSIGN - EXTERNAL ZONE (G)
Th is is for setting the External Zone corresponding with the footage selected in
ASSIGN - CONTROL CHANGE NUMBER (G)
Th is is for setting the control change number corresponding with the footage selected
in .
Th e setting range is 1:MOD -- 95:PHASER (Nothing to do with the built-in phaser in
this keyboard).
ACTIVE DRAWBARS
⓳ ⓴
Mode Assign
C
C D
Off
A /B
Off
Always A
A /B On
On
Always A

DISPLAY

⓱ DISPLAY - SHORT CUT (G)
Sets the short cut waiting time.
Th e setting range is 0 to 2 seconds. At NO the short cut feature is disabled.
⓲ DISPLAY - TIME OUT (G)
Sets the time for returning to the previous mode from the mode displayed by the short
cut operation.
Th e setting range is 4 to 16 seconds. At NO the screen will not return to the previous
mode.
⓳ DISPLAY - POP UP (G)
Sets the interval at which the Pop Up is displayed when you move the [OVERDRIVE],
[EFFECT] and [REVERB] knob.
Th e setting range is 0.5 to 2 seconds. At NO no Pop Up is displayed.
D F G A C
E F G A B C
.
Preset Key
D F G A C
E F
D G A B C
ASSIGNABLE DRAWBARS
This keyboard can control the external MIDI
equipment using the External Zone (P. 126).
In that case, the function to use the LOWER [B]
Drawbar as the controller for sending various
control changes is called "ASSIGNABLE DRAW-
BAR".
The registration is adjusted with the Drawbar
[A#] when the Preset Key [B] is selected while
using the Assignable Drawbar.
D F G A
E F
D G A B
NOTE: The parameter with (P) indicated is
a Patch parameter, and is recorded
to each Patch. (G) indicates "global
parameter", which is recorded upon
being set, and is common with each
Patch.
81