Default - Hammond XK-5 Owner's Manual

112
In this mode, you can go back totally or partially to the factory default settings.
To locate this mode:
MENU/EXIT
❾
❺
❶
To initialize each parameter, select the parameter you want to
initialize with the [ ][ ] button and press the [ENTER] but-
ton.
❶ ADJUST PRESET
Initializes the contents of the Preset Key [A ] and [B].
Used to create a "clean slate" for new Patch settings.
❷ PATCH
Th is is for initializing the User Patch contents (from Factory
Patch with same Patch number). Select the Patch you want to
initialize with the [VALUE] knob. Th e selecting range is U00
to U99 and ALL (All User Patches).
❸ GLOBAL
Th is is for initializing the Global Parameters such as the Master
Tune or assignment of the Foot Switch.
❹ CUSTOM LESLIE CABINETS
Th is is for initializing the contents of all internal Leslie Cabi-
nets. Select the number you want to initialize with the [VAL-
UE] knob. Th e selecting range is U1 to U8 and ALL (All User
Cabinets).
❺ CUSTOM TONE WHEELS
Th is is for initializing the contents of all Custom Tone Wheels.
Select the number you want to initialize with the [VALUE]
knob. Th e selecting range is shown as below and ALL (All Cus-
tom Tone Wheels).
A-U1: A-100, U1
A-U2: A-100, U2
A-U3: A-100, U3
B-U1: B-3, U1 (similarly)
C-U2: C-3, U1 (similarly)
M-U1: Mellow, U1 (similarly)
❻ CUSTOM CONTACTS
Th is is for initializing the contents of all Custom Contacts. Se-
lect the number you want to initialize with the [VALUE] knob.
Th e selecting range is U1 to U3 and ALL (All User Contacts).
Owner's Manual

DEFAULT

❻
❷
❼ PEDAL REGISTRATION
Th is is for initializing the contents of all Pedal Sub Drawbars.
Select the number you want to initialize with the [VALUE]
knob. Th e selecting range is U1 to U3 and ALL (All User Pedal
Sub Drawbars).
❽ CUSTOM PIPES
Th is is for initializing the contents of all Custom Pipe Stops.
Select the number you want to initialize with the [VALUE]
knob. Th e selecting range is U1 to U3 and ALL (All User Pipe
Stops).
❾ ALL
Th is is for initializing all parameters of this keyboard.
If any unstable condition occurs on this keyboard system, ini-
tializing "all" will usually clear the problem.
NOTE: You can also totally initialize this keyboard by switching the
power ON while pressing and holding the [RECORD] button.
ENTER
❼
❸
❽
❹