Installing And Removing Expansion Cards; Remove The Bus Frame - Siemens SIMATIC IPC647E Operating Instructions Manual

Expanding and assigning parameters to the device

6.2 Installing and removing expansion cards

6.2 Installing and removing expansion cards
6.2.1

Remove the bus frame

Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 46)".
• Screwdriver T10
Procedure
1. Fully disconnect the device from the line voltage, see "Switching off the device (Page 66)".
2. Open the device. Be sure to follow the important instructions under "Open the device
(Page 97)".
3. Remove the 4 screws ① with which the bus frame is mounted in the device.
4. Pull the bus frame carefully and evenly upwards out of the device at the marked points ②.
When doing this, do not tilt the bus frame.
98
Operating Instructions, 09/2022, A5E52254141-AA
SIMATIC IPC647E