Removing And Installing The 3.5" Drive In The Drive Bay - Siemens SIMATIC IPC647E Operating Instructions Manual

6.6.2.2

Removing and installing the 3.5" drive in the drive bay

Requirements
• The device is equipped with the drive cage type B.
• There are no internal drives above the drive cage.
You can find information on removing the internal drives in "Removing and installing a
2.5" drive (internal) via drive cage (Page 128)".
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 46)".
• You know the information under "Installation options for drives with drive cage type B
(Page 123)".
• An original spare part, that is, a drive approved for this device.
• The device is fully disconnected from the mains power supply, see "Switching off the
device (Page 66)".
• The device is open, see important information under "Open the device (Page 97)".
• The drive you want to change is inactive, see "System status displays (Page 27)".
Procedure
Removal of an existing drive
1. Open the front door of the device.
2. Unlock the cover of the drive cage (Page 20) from the inside.
To do this, press down the marked area with a suitable object (e.g. with a screwdriver)
until the cover on the drive cage is released.
3. Remove the cover from the front of the device.
SIMATIC IPC647E
Operating Instructions, 09/2022, A5E52254141-AA
Expanding and assigning parameters to the device
6.6 Installing and removing drives
125