Table of Contents
Advertisement
AMI Solicon4
Program List and Explanations
2.2.2
2.2.2.1
2.3 Sample
2.3.1
2.4 I/O State
2.4.1/2.4.2
2.5 Interface
54
Miscellaneous:
Case Temp: Shows the current temperature in °C inside the trans-
mitter.
Sample ID: Shows the identification assigned to a sample. This
identification is defined by the user to identify the location of the
sample.
Temperature: Shows the current sample temperature in °C.
(Pt 1000): Shows the current sample temperature in Ohm.
Sample Flow: If Q-Flow is chosen
Shows the current sample flow in l/h
Raw Value: shows the sample flow in Hz.
Sample Flow: If deltaT is chosen
Shows the current sample flow in l/h
deltaT 1: Temperature measured at sample inlet of the
deltaT sensor
deltaT 2: Temperature measured at sample outlet of the
deltaT sensor
Shows current status of all in- and outputs.
Alarm Relay:
Relay 1 and 2:
Input:
Signal Output 1 and 2:
Signal Output 3 (option): Actual current in mA
Only available if optional interface is installed.
Review programmed communication settings.
Inactive or active
Inactive or active
Open or closed
Actual current in mA
A-96.250.321 / 191015
Advertisement
Table of Contents
