Changing Parameters And Values - Swann AMI Solicon4 Operator's Manual

AMI Solicon4
Operation
5.4.
Changing
parameters
Changing
values
A-96.250.321 / 191015

Changing Parameters and values

The following example shows how to change the logger interval:
Logger Sensors
Sensor type
Log interval
Disinf. Free chlorine
Clear logger
Temperature
Standards
Logger
Interval.
Log interval
Clear logger 5 min
10 min
30 min
1 Hour
Logger
Log interval
Clear logger
Logger
Log interval
Save ?
Clear logger
Yes
No
Alarm Conductivity
Alarm High 300 mS
Alarm Low 0.00
Hysteresis 1.00
Delay
Alarm Conductivity
Alarm High 120 mS
Alarm Low 0.00
Hysteresis 1.00
Delay
1 Select the parameter you want to
4.4.1 5.1.2
change.
FOME
30 min
2 Press [Enter]
no
NT5K
3 Press [
4.1.3
highlight the required parameter.
30min
4 Press [Enter] to confirm the selec-
no
tion or [Exit] to keep the previous
parameter).

The selected parameter is
4.1.3
highlighted but not saved yet.
10 min
5 Press [Exit].
no

Yes is highlighted.
4.1.3
6 Press [Enter] to save the new pa-
rameter.
no

The system reboots, the new
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
 2 Press [Enter].
S

S
3 Set required value with [
5 Sec
[
4 Press [Enter] to confirm the new
5.3.1.1.1
value.
 5 Press [Exit].
S


Yes is highlighted.
S
5 Sec
6 Press [Enter] to save the new val-
ue.
] or [ ] key to
] key.
] or
39