Chrysler Concorde 2004 Service Manual page 1209

P0706-CHECK SHIFTER SIGNAL —
TEST
19 Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
Repair
20 If there are no possible causes remaining, view repair.
Repair
21 The conditions necessary to set the DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring and connectors while checking for shorted and open circuits.
Check the Shift Linkage and cable for proper operation per the Service Information.
With the DRBIII , check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Perform *PRNDL FAULT CLEARING PROCEDURE after completion of any repairs.
Were there any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Replace the Powertrain Control Module per the Service Informa-
tion. WITH THE DRBIII
REPROGRAM PINION FACTOR.
Perform 42LE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Adjust the Shift Linkage and/or cable per the Service Information.
Perform 42LE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Perform 42LE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
TRANSMISSION - NGC
Continued
PERFORM QUICK LEARN AND
49
APPLICABILITY
All
All
All