Chrysler Sebring 2004 Service Manual page 1326

JR
T850 MANUAL TRANSAXLE (Continued)
(30) Install back up lamp switch and torque to 23
N·m (17 ft. lbs.) (Fig. 54).
Fig. 54 Back-Up Lamp Switch
1 - BACK-UP LAMP SWITCH
(31) Apply a 1 mm (0.04 in.) bead of Mopar Gas-
ket Maker to shift cover assembly. Place shift cover
and transaxle geartrain into neutral and install shift
cover (Fig. 55) and torque bolts to 28 N·m (250 in.
lbs.).
Fig. 55 Shift Cover Removal/Installation
1 - SHIFT COVER ASSEMBLY
T850 MANUAL TRANSAXLE
(32) Install input shaft bearing retainer (Fig. 56).
Torque bolts to 12 N·m (105 in. lbs.).
Fig. 56 Input Bearing Retainer
1 - INPUT BEARING RETAINER
(33) If previously removed, install clutch release
lever pivot ball(s) using slide hammer C-3752 and
remover/installer 6891 (Fig. 57) (Fig. 58).
Fig. 57 Pivot Ball Removal/Installation
1 - C-3752 SLIDE HAMMER
2 - REMOVER/INSTALLER 6891
3 - PIVOT BALL
21 - 65