Table of Contents
Advertisement
JR
FUEL LEVEL SENDING UNIT / SENSOR (Continued)
REMOVAL
Remove fuel pump module. Refer to Fuel Pump
Module in this section.
(1) Depress retaining tab and remove the fuel
pump/level sensor connector from the bottom of the
fuel pump module electrical connector (Fig. 2) and
(Fig. 3).
Fig. 2 ELECTRICAL CONNECTOR
Fig. 3 Fuel Pump/Level Sensor Electrical Connector
1 - RETAINING TAB
2 - ELECTRICAL CONNECTOR
(2) Pull off locking wedge (Fig. 4).
(3) Using a small screwdriver lift locking finger
away from terminal and push level sensor and
ground terminals out of connector (Fig. 5).
(4) Push level sensor signal and ground terminals
out of the connector (Fig. 5).
Fig. 4 Wire Terminal Locking Wedge
1 - ELECTRICAL CONNECTOR
2 - LOCKING WEDGE
Fig. 5 Removing Wires From Connector
1 - LOCKING FINGER
2 - WIRE TERMINAL
(5) Use screwdriver to move locking tab on level
sensor and move level sensor down channel to
remove (Fig. 6) and (Fig. 7).
(6) Slide level sensor out of installation channel in
module.
INSTALLATION
(1) Insert level sensor wires into bottom of opening
in module.
(2) Wrap wires into groove in back of level sensor.
(3) While feeding wires into guide grooves, slide
level sensor up into channel until it snaps into place.
Ensure tab at bottom of sensor locks in place.
(4) Install level sensor wires in connector. Push
the wires up through the connector and then pull
them down until they lock in place. Ensure signal
and ground wires are installed in the correct posi-
tion.
(5) Install locking wedge on connector.
(6) Push connector up into bottom of fuel pump
module electrical connector.
FUEL DELIVERY
14 - 5
Advertisement
Table of Contents
