Chrysler Sebring 2004 Service Manual page 1287

21 - 26 T350 MANUAL TRANSAXLE
DIFFERENTIAL (Continued)
Fig. 70 Checking Differential Bearing End Play to
Determine Shim Thickness
1 - T-HANDLE
2 - DIAL INDICATOR SET
3 - SPECIAL TOOL C-4995
(9) Install clutch bellhousing. Install and torque
case bolts to 26 N·m (19 ft. lbs.).
(10) Using Special Tool C-4995 and an inch-pound
torque wrench, check turning torque of the differen-
tial assembly (Fig. 71). The turning torque should
be 6 to 12 in. lbs. If the turning torque is too
high, install a 0.05 mm (0.002 inch) thinner
shim. If the turning torque is too low, install a
0.05mm (0.002 inch) thicker shim.
Fig. 71 Checking Differential Bearing Turning
1 - INCH-POUND TORQUE WRENCH
2 - SPECIAL TOOL C-4995
(11) Recheck turning torque. Repeat Step 10 until
the proper turning torque is obtained.
Torque
DIFFERENTIAL BEARING
CUPS
REMOVAL
(1) Remove differential assembly from gear case
using the procedure outlined in this group.
(2) Install Miller tool #L-4518 into the differential
bearing cup (Fig. 72).
Fig. 72 Tool Installed in Bearing
1 - SPECIAL TOOL L-4518
2 - GEAR CASE
(3) Install the tool cup over the tool (Fig. 73).
Fig. 73 Tool Cup Installed
1 - GEAR CASE
2 - SPECIAL TOOL L-4518
3 - WRENCH
(4) Tighten the tool until the race is removed from
the case.
JR