Chrysler Sebring 2004 Service Manual page 1028

JR
ROCKER ARMS (Continued)
(5) Using Special Tools 8215-A and 8436 slowly
depress valve assembly until rocker arm can be
removed (Fig. 28).
(6) Repeat removal procedure for each rocker arm.
Fig. 28 Rocker Arm - Removal/Installation
1 - SPECIAL TOOL 8215-A
2 - SPECIAL TOOL 8436
3 - 3/8 DRIVE RACHET
INSPECTION
Inspect the rocker arm for wear or damage (Fig.
29). Replace as necessary.
Fig. 29 Rocker Arm
1 - TIP
2 - LASH ADJUSTER POCKET
3 - ROLLER
INSTALLATION
(1) Lubricate rocker arm with clean engine oil.
(2) Using Special Tools 8215-A and 8436 slowly
depress valve assembly until rocker arm can be
ENGINE 2.4L DOHC
installed on the hydraulic lifter and valve stem (Fig.
28).
(3) Repeat installation procedure for each rocker
arm.
(4) Install spark plugs.
(5) Install cylinder head cover. (Refer to 9 -
ENGINE/CYLINDER
COVER(S) - INSTALLATION)
(6) Connect negative battery cable.
VALVE SPRINGS & SEALS
REMOVAL
REMOVAL - CYLINDER HEAD ON
(1) Disconnect negative battery cable.
(2) Remove timing belt (Refer to 9 - ENGINE/
VALVE TIMING/TIMING
SPROCKETS - REMOVAL).
(3) Remove cylinder head cover (Refer to 9 -
ENGINE/CYLINDER
COVER(S) - REMOVAL).
(4) Remove camshafts (Refer to 9 - ENGINE/CYL-
INDER HEAD/CAMSHAFT(S) - REMOVAL).
(5) Rotate crankshaft until piston is at TDC.
(6) With air hose attached to adapter tool installed
in spark plug hole, apply 90-120 psi air pressure.
(7) Using Special Tool MD-998772-A with adapter
6779 (Fig. 30), compress valve springs and remove
valve locks.
(8) Remove valve spring(s).
(9) Remove valve stem seal(s) by a using valve
stem seal tool (Fig. 32).
Fig. 30 Valve Spring - Removal/Installation
1 - VALVE SPRING COMPRESSOR MD 998772A
2 - AIR HOSE
9 - 101
HEAD/CYLINDER
BELT/CHAIN
HEAD/CYLINDER
HEAD
AND
HEAD