Table of Contents
Advertisement
21 - 20
T350 MANUAL TRANSAXLE
BACK-UP LAMP SWITCH
REMOVAL
(1) Lift vehicle on hoist.
(2) From bottom side of vehicle, disconnect back-up
lamp switch connector (Fig. 49).
Fig. 49 BACK-UP LAMP SWITCH
1 - CONNECTOR
2 - BACK UP LAMP SWITCH
(3) Unscrew switch from transaxle.
INSTALLATION
(1) Install back-up lamp switch. Teflon tape or
equivalent must be used on switch threads. Tighten
switch to 24 N·m (18 ft. lbs.) torque.
CAUTION: Do not overtighten switch.
(2) Connect back-up lamp switch connector (Fig.
49).
(3) Lower vehicle.
(4) Verify back-up lamp operation.
DIFFERENTIAL
DISASSEMBLY
(1) Remove differential bearing cones (ring gear
and diff. case side) using Tool C-293-PA, Adapters
C-293-45, and Tool 4996 (Fig. 50) (Fig. 51).
Fig. 50 Remove Differential Bearing Cone from Diff.
Case Side
1 - SPECIAL TOOL C-293-PA
2 - SPECIAL TOOL C-4996
3 - DIFFERENTIAL ASSEMBLY
4 - SPECIAL TOOL C-293-45
Fig. 51 Remove Differential Bearing Cone from Ring
Gear Side
1 - SPECIAL TOOL C-293
2 - SPECIAL TOOL ADAPTER C-293-45 (USE 4 PIECES)
3 - DIFFERENTIAL ASSEMBLY
4 - DIFFERENTIAL BEARING CONE
5 - SPECIAL TOOL C-4996 (NOTE POSITION)
JR
Advertisement
Table of Contents
