Rear Door Glass; Rear Door Outside Handle - Chrysler Sebring 2004 Service Manual

JR
DOOR GLASS
REMOVAL
(1) Remove door trim panel and inner belt weath-
erstrip.
(2) Connect power window switch or install crank
and lower window to 50 mm (2 in.) from bottom of
travel.
(3) Loosen bolts holding rear lower run channel to
inner door panel (Fig. 4).
(4) Separate rear run channel from door.
(5) Loosen screws holding regulator roller channel
to glass.
(6) Slide roller channel rearward to allow screw
heads to pass through key hole slots in channel.
(7) Separate glass from roller channel.
(8) Lift glass upward and out of the opening at top
of door.
Fig. 4 Rear Door Glass

1 - REAR DOOR GLASS

2 - LOWER RUN CHANNEL
3 - REAR DOOR
4 - LIFT CHANNEL
INSTALLATION
(1) Lower door glass through opening at top of
door.
(2) Position door glass onto roller channel.
(3) Slide roller channel forward to allow screw
heads to engage key hole slots in channel.
(4) Tighten screws holding regulator roller channel
to glass.
(5) Position rear run channel on door.
(6) Tighten bolts holding rear lower run channel to
inner door panel.
(7) Install door trim panel and inner belt weather-
strip.
EXTERIOR HANDLE
REMOVAL
(1) Remove rear door trim panel.
(2) Close door glass.
(3) Disengage clip holding linkage to outside han-
dle.
(4) Remove linkage from outside handle (Fig. 5).
(5) Remove nuts holding outside handle to outer
door panel.
(6) Remove outside door handle from vehicle.
Fig. 5 Rear Door Outside Handle
1 - OUTSIDE DOOR HANDLE
2 - REAR DOOR
3 - LINKAGE
INSTALLATION
(1) Position outside door handle from vehicle.
(2) Install nuts attaching outside handle to outer
door panel.
(3) Connect linkage to outside handle (Fig. 5).
(4) Connect clip holding linkage to outside handle.
(5) Replace the clips attaching trim panel to
perimeter of door.
(6) Install rear door trim panel.
DOORS - REAR 23 - 47