Chrysler Sebring 2004 Service Manual page 1128

JR
REAR MOUNT
REMOVAL
(1) Remove throttle body air inlet hose and air
cleaner housing assembly.
(2) Remove three vertical bolts attaching rear
mount bracket to transaxle case (Fig. 83).
(3) Raise vehicle on hoist.
(4) Remove rear mount bracket through bolt (Fig.
83).
(5) Remove horizontal bolt attaching rear mount
bracket to transaxle case (Fig. 83).
(6) Remove mount bracket.
(7) Remove rear mount to suspension crossmember
attaching bolts.
(8) Remove rear mount.
Fig. 83 Engine Mounting—Rear
1 - REAR TORQUE BRACKET
2 - REAR MOUNT
3 - THROUGH BOLT
INSTALLATION
(1) Position rear mount on suspension crossmem-
ber and loosely install bolts.
(2) Position mount bracket on transaxle and install
bolts. Tighten to 110 N·m (80 ft. lbs.) (Fig. 73).
(3) Install rear mount to bracket through bolt and
tighten to 61 N·m (45 ft. lbs.) (Fig. 73).
(4) Tighten rear mount to crossmember bolts to 61
N·m (45 ft. lbs.) (Fig. 73).
(5) Lower vehicle. Install throttle body air inlet
hose and air cleaner housing assembly.
ENGINE 2.7L DOHC
RIGHT MOUNT
REMOVAL
(1) Remove coolant pressure container (Refer to 7 -
COOLING/ENGINE/COOLANT RECOVERY PRESS
CONTAINER - REMOVAL).
(2) Remove heater tube front attaching screw.
(3) Raise vehicle on a hoist and remove inner
splash shield.
(4) Remove heater tube rear attaching screw.
(5) Remove the right engine support assembly ver-
tical fasteners from frame rail (Fig. 84).
(6) Lower vehicle. Remove the load on the engine
motor mounts by carefully supporting the engine
assembly with floor jack and wooden block on oil
pan.
(7) Remove the bolts attaching the engine support
assembly to the engine bracket (Fig. 84).
(8) Remove right engine mount.
Fig. 84 Engine Mounting—Right Side
1 - ENGINE SUPPORT BRACKET
2 - FRAME RAIL
3 - RIGHT ENGINE MOUNT
INSTALLATION
(1) Position right engine mount and install frame
rail to mount bolts. Tighten bolts to 61 N·m (45 ft.
lbs.) (Fig. 84).
(2) Install the mount to engine support bracket
bolts and tighten to 61 N·m (45 ft. lbs.) (Fig. 84).
(3) Raise vehicle on a hoist.
(4) Install heater tube rear attaching screw.
(5) Install inner splash shield and lower vehicle.
(6) Install heater tube front attaching screw.
(7) Install coolant bottle (Refer to 7 - COOLING/
ENGINE/COOLANT
TAINER - INSTALLATION).
RECOVERY PRESS
9 - 201
CON-