Table of Contents
Advertisement
JR
RESERVOIR (Continued)
(2) Using a siphon pump, remove as much power
steering fluid as possible from the power steering
fluid reservoir.
(3) Remove screw fastening reservoir to engine
coolant recovery bottle (Fig. 12).
(4) Lift reservoir off guide on engine coolant recov-
ery bottle.
(5) Remove hose clamps attaching power steering
fluid supply hose and return hose to reservoir.
(6) Remove power steering fluid supply and return
hoses from reservoir and remove reservoir from vehi-
cle.
INSTALLATION
(1) Install power steering fluid return and supply
hoses on power steering fluid reservoir fittings (Fig.
12). Be sure both hose clamps are installed on
hose past upset bead on power steering reser-
voir fittings.
(2) Slide reservoir down over guide on engine cool-
ant recovery bottle.
(3) Install power steering fluid reservoir mounting
screw and tighten to 6 N·m (53 in. lbs.).
(4) Install remote battery ground cable on ground
stud located on left shock tower.
(5) Fill power steering pump fluid reservoir to the
proper level.
(6) Start the engine and let run for a few seconds,
then turn the engine off.
(7) Adjust fluid level if necessary. Repeat steps (5)
and (6) until the fluid level remains constant after
running the engine. If necessary perform Power
Steering Pump Initial Operation standard procedure.
(Refer to 19 - STEERING/PUMP - STANDARD PRO-
CEDURE)
(8) Check for leaks.
PUMP
19 - 39
Advertisement
Table of Contents
