Chrysler Sebring 2004 Service Manual page 1483

21 - 222 41TE AUTOMATIC TRANSAXLE
SHIFT INTERLOCK CABLE (Continued)
ADJUSTMENT
(1) Disconnect and isolate, the battery negative
cable.
(2) Remove the gearshift knob set screw and knob
(Fig. 287).
Fig. 287 Gearshift Knob
1 - GEARSHIFT KNOB
2 - SET SCREW
3 - GEARSHIFT MECHANISM
(3) Remove the gearshift bezel to gain access to
the interlock cable adjuster lock (Fig. 288).
Fig. 288 Gearshift Bezel
1 - CENTER CONSOLE ASSEMBLY
2 - GEARSHIFT BEZEL
3 - LAMP CONNECTOR
(4) Re-install the gearshift knob set screw and
knob (Fig. 287).
(5) Place the shift lever in PARK. Move the Igni-
tion key to the LOCK position (Fig. 286) and remove
the key.
(6) If the interlock cable is being replaced, remove
the lock pin (Fig. 289). This will allow the cable to
"self adjust" to the correct position. Tighten the lock-
ing clip by pushing it down (Fig. 290).
Fig. 289 Interlock Cable Locking Pin
1 - SHIFT MECHANISM
2 - LOCKING PIN
3 - INTERLOCK CABLE
JR