Document Conventions; Audiocodes Software Releases; References - AudioCodes MP-11x Configuration Manual

Audiocodes T.38 FAX Configuration Guide
SNMPManagerTableIP_2 = 0.0.0.0
SNMPManagerIsUsed_2 = 0
Because the INI file numbering is zero-based, this example shows that the third SNMP
manager in the table has not been enabled.
The INI file can be easily retrieved from the media gateway by either the WEB or EMS.
IMPORTANT NOTE: The INI file only shows a parameter value when it differs from the
default. When a parameter is not found in the INI file, it can be assumed to be at the
default value.
1.5

Document Conventions

In most cases, a screen capture of the referenced parameter will be provided for both the
web GUI and the EMS view. The user should reference the screen which matches the
management mode for the deployment (either Web or EMS). For clarity, each referenced
parameter will first be discussed by referencing the INI file name (for example,
ALTROUTINGTEL2IPENABLE). The reference will be followed by a short definition
which will include a description of valid ranges and default values.
1.6

AudioCodes Software Releases

Each AudioCodes software release will have four numerical indicators, for example
6.2.34.4. The first two numbers indicate the major release. This indicator progresses as
follows: 5.0, 5.2, 5.4, 5.6, 5.8, 6.0, 6.2, etc. The second two indicators represent the
minor release. In general, the minor release indicators are not usually significant to end
users.
The software version can be easily determined from either the web or EMS views. The
software version can be referred to with leading or trailing zeroes which can be ignored.
For example, the web GUI may display a version 06.20.034.004 for the 6.2 version
referenced above. In some cases, a letter designation will be included, as in
6.20A.043.002.
This manual in general is applicable to the 6.0 and 6.2 versions. The screens are captured
from the 6.2 version and may vary slightly from version to version.
1.7

References

The last 3 digits of the document reference number (beginning with LTRT) vary by
release. These digits are replaced by xxx in the table below.
LTRT-59xxx MP-11x and MP-124 SIP Installation Manual Ver. 6.x.pdf
LTRT-65xxx_MP-11x_and_MP-124_SIP_User's_Manual_Ver_6.x.pdf
LTRT-66xxx CPE Configuration Guide for IP Voice Mail Ver 6..x.pdf
LTRT-26xxx SIP CPE Release Notes Ver. 6.x.pdf
Verizon T.38 FAX Configuration Guide for AudioCodes MP-11x
Version 1.0
Page 8
30-APR- 2011
Page 8 of 42