Cli; Commands Available; Netconf; Help - Eaton Network-M2 User Manual

CLI
.1.3.6.1.4.1.534.1.11.4.1.0.43
.1.3.6.1.4.1.534.1.11.4.1.0.48

6.8 CLI

CLI can be accessed through SSH. It is intended mainly for automated configuration of the network and time
settings of the network card. It can also be used for troubleshooting and remote reboot/reset of the network
interface in case the web user interface is not accessible.
Warning: Changing network parameters may cause the card to become unavailable remotely. If this
happens it can only be reconfigured locally through USB.

6.8.1 Commands available

6.8.2 Netconf

Help

Usage: netconf [OPTION]...
Display network information and change configuration.
-h, --help display help page
-L, --lan display Link status and MAC address
-L, --lan <link speed>
Link speed values:
auto Auto Negotiation
10hf 10 Mbps - Half duplex
10ff 10 Mbps - Full duplex
100hf 100 Mbps - Half duplex
100ff 100 Mbps - Full duplex
1000auto 1000 Mbps - Auto negotiation
-d, --domain display Domain mode, FQDN, Primary and Secondary DNS
-d, --domain hostname <hostname> set custom hostname
-d, --domain <mode>
Mode values:
manual <domain name> <primary DNS> <secondary DNS> set custom Network address,
Netmask and Gateway
dhcp automatically set Domain name, Primary and Secondary DNS
-6, --ipv6 display IPv6 Mode, Addresses and Gateway
-6, --ipv6 <status>
Status values:
enable enable IPv6
disable disable IPv6
-6, --ipv6 <mode>
Mode values:
manual <network> <prefix> <gateway> set custom Network address, Prefix and Gateway
router automatically set Network address, Prefix and Gateway
-4, --ipv4 display Mode, address, Netmask and Gateway
Information – 108
Sensor humidity is below/above critical threshold
Maintenance bypass