Freedom Sw 230V Ac And Dc Side Panels - Xantrex Freedom SW 230V 815-3524-02 Owner's Manual

Freedom SW 230V AC and DC Side Panels

The DC side of the Freedom SW 230V has the equipment ground
lug, the positive (+) battery terminal, and the negative (-) battery
terminal plus the remote network com port and battery temperature
sensor com port.
1 2 3
CAUTION: INCORRECT BATTER
BTS
REM
4 10
Figure 6 AC and DC Side Panel
975-0696-01-01
5
WIRING BOX COVER MUST BE IN PLACE DURING
OPERATION TO REDUCE RISK OF INJURY TO PERSONS.
AC
OUT
AC GROUNDS
(BEHIND COVER)
7
8
6
9
Freedom SW Inverter/Charger Mechanical Features
Item Description
1 Remote (REM) jack provides connection for the Freedom
Sine Wave remote panel.
2 Battery temperature sensor (BTS) jack provides connection
for the battery temperature sensor (supplied).
3 Negative (–) DC terminal connects to the negative battery
cable (black). Install a DC terminal cover (supplied) over the
terminal.
4 Positive (+) DC terminal connects to the positive battery
cable (red).
Install a DC terminal cover (supplied) over the terminal.
5 AC Input circuit breaker switch allows you to reset the
circuit breakers when they trip. See "Shore (Shr) setting" on
page 24 and "ACIn Breaker" on page 44.
6 AC knockouts provide access for AC cables (both input and
output wiring). Detach the knockout covers and install strain-
relief clamps available in hardware and electrical stores.
7 AC Input terminal block is a screw-type terminal block for
attaching AC input wires. Labeled INPUT N for Neutral and
INPUT L for Line.
8 AC Output terminal block is a screw-type terminal block for
attaching AC output wires. Labeled OUTPUT N for Neutral
and OUTPUT L for Line.
9 Earth/Ground terminals along the tab at the bottom of the
opening to the AC wiring compartment access panel
10 Chassis ground lug connects the chassis of the Freedom SW
to your system's chassis grounding point.
11