Freedom SW Inverter/Charger Mechanical Features
Freedom SW 230V Supplied Accessories
Figure 7 Supplied Accessories
NOTE: If any of the supplied accessories are missing, contact
customer service or any authorized dealer for replacement.
12
1
2
3
4
Item
Description
1
Two DC terminal covers are supplied to prevent accidental
contact with the DC cable connectors after installation. The red
cover is for the positive cabling terminal, and the black cover
is for the negative cabling terminal.
2
BTS, the Battery Temperature Sensor consists of:
• Connector plugs into the BTS jack on the Freedom SW.
• Sensor cable is 7.6 meters.
• Sensor can be mounted on the side of the battery case or on
the negative battery terminal.
NOTE: The BTS continuously measures the temperature of
the battery and adjusts the charger output for a more accurate,
temperature-compensated charge.
3
Two sets of nuts and washers are used to secure DC cable
ends to the DC terminals.
4
Two Xanbus network terminators are used to properly
terminate each of the two ends of the daisy-chained Xanbus
network. For example, if the Xanbus SCP is connected to the
inverter/charger, one terminator will be plugged to the SCP,
one network cable will connect both devices, and one
terminator will be plugged to the inverter/charger.
IMPORTANT: The Xanbus SCP may perform erratically if
the Xanbus network is not properly terminated.
Freedom SW 230V Owner's Guide