Changing Configurable Settings From The Device Setup Menu Screen - Xantrex Freedom SW 230V 815-3524-02 Owner's Manual

Changing Configurable Settings From The Device Setup Menu Screen

The Freedom SW 230V can only be configured using the Xanbus
SCP. Follow the procedure in "To view the Freedom SW 230V
Setup menu screen:" on page 29 to bring up the device setup screen
for the Freedom SW inverter/charger.
FSW3524E 00: Setup
Mode Invert
Battery 23.6V -44.0A N/A
Load 915W 230V 4A
AC In 0V 0A 0Hz
Advanced Settings
Inverter [Enabled]
Search Mode [Disabled]
Charger [Disabled]
Force Chg State
Equalize [Disabled]
Desired Mode [Standby]
Clear Faults Warnings
View Device Info
Basic Settings
Figure 21 Freedom SW 230V Device Setup Menu
As discussed in "Reading the Freedom SW 230V Device Setup
Screen" on page 29 the Freedom SW Device Setup menu screen has
two segments. The first segment (lines 2 to 5) displays status
information and appears first in the screen's initial four lines. The
second segment (lines 6 to 15) contains selectable fields which are
configurable settings.
975-0696-01-01
Line 1
NOTE: The Xanbus SCP only
Line 2
displays four lines of the
Line 3
device Setup menu at once.
Line 4
To view configurable settings,
Line 5
press the Down arrow button.
Line 6
Line 7
Line 8
Line 9
Line 10
Line 11
Line 12
* appears only when Enter,
Line 13
Up, and Down arrow buttons
Line 14
are pressed together.
Line 15
Configuring the Freedom SW using the SCP
These configurable settings are:
• Advanced settings
• Inverter
• Search mode
• Charger
• Force charge
• Equalize
• Desired mode
• Clear fault settings
• View device info
• Basic settings
Only nine of these settings are displayed at a time. The Advanced
Settings (Line 6) is not initially listed and only lines 7 through 15
appear. When the Advanced Settings is listed, it will appear on top
of the list for configurable settings and the setup screen will display
lines 6 through 14.
See Table 5, "Configurable Settings" on page 39 for information on
each setting.
37