Reading The System Status Screen - Xantrex Freedom SW 230V 815-3524-02 Owner's Manual

Operating the Freedom SW with the SCP

Reading the System Status Screen

The System Status screen displays:
• Battery-related information (see Line 2)
• Battery level and inverter/charger operating state (see Line 3)
• Load information (see Line 4)
• AC Input information (see Line 5)
Field 1
Field 4
Field 6
System Status
Battery 24.2V -128A 29"C
BatLev
Load 230V
AC In 0V
menu EnInv
Field 9
Menu arrow indicates the Enter
button. Pressing Enter displays
the Select Device menu.
28
Field 2 Field 3
Field 5
Field 7 Field 8
Line 1
Line 2
Line 3
Invert
Line 4
10A 6A
Line 5
0A 0A
EnChg Shr
Field 10 Field 11
Table 2 System Status Screen
Line 1 Label: "System Settings"
Line 2 Label: Battery
Field 1: Battery voltage
Field 2: Total battery current. Negative value if the battery is discharging and
positive value when charging.
Field 3: Battery temperature
stacked inverters that are installed.
Line 3 Label: BatLev
Field 4: Displays a bar graph showing the approximate battery level.
Field 5: Freedom SW inverter/charger operating state
Line 4 Label: Load
Field 6: Inverter output voltage at load terminals of the inverter/charger. Voltage
is reported by the Master unit if more than one inverter/charger is installed.
b
Field 7: Master current
Field 8: It displays Slave current
Line 5 Label: AC In
Field 9: AC input voltage at AC In terminals of the inverter/charger. Voltage is
reported by the Master unit if more than one inverter/charger is installed.
b
Field 10: Master current
Field 11: It displays Slave current
a. The unit of temperature can be changed in the SCP Config menu screen.
b. When in a stacked inverter configuration.
c. In a single unit setup, the Slave will display 0A all the time mainly because of the absence
of a second unit. If two units are stacked, the Master and Slave current will display the appro-
priate current values.
a
. Also, displays the highest temperature between
c
.
c
.
Freedom SW 230V Owner's Guide